Installing electrical accessories in any vehicle can be challenging. Add the limited areas to work with in a Jeep, and it's even t

3) Remove the passenger sun visor (photo 3). Photo 3 4) Loosen, but do not remove the 3 attaching screws on the passenger side pillar cover (ph

8) Route the wires to the passenger side and down the pillar through the dash (photo 8). Then re-tighten 3 pillar screws loosened in step 4 & re-

12) Re-install the battery (photo 12). Photo 12 13) Remove the 4 screws attaching the power source to the mounting bracket (photo 13). Photo 13

After installation !!!Must start engine to activate system!!! 18) Connect positive, then negative terminals to battery (photo 18). Photo 18 19)